Circuit Wiring Solution: motorcycle

Showing posts with label motorcycle. Show all posts

Wednesday, August 27, 2014

Honda Motorcycle CB750F Wiring Diagram

The circuit shows the wiring diagram of electrical connection for the Honda CB750F motorcycle. It shows the connection between the parts for Honda, as the indicator light to the right of the signal, oil pressure warning light, neutral indicator, high beam indicator, signal indicator lamps, tachometer, speed indicator lights, turn signal / navigation lights, headlights, turn signals / running light, horn and horn button, clutch switch, front stop switch, turn the switch on the control signal, controller voltage, engine stop switch, ignition units, neutral switch, the oil pressure switch, rear stop switch, fuses, ignition switch, starter, battery, turn signal rear right tail and brake light, rear turn signal on the left, the regulator / rectifier, alternator, ignition coils, pulse generator, spark plugs, and the color code.

Sunday, August 17, 2014

Motorcycle Alarm Wiring diagram Schematic

This is a Motorcycle Alarm Circuit Diagram. Any number of normally open switches may be used. Fit the mercury switches so that they close when the steering is moved or when the bike is lifted off its side-stand or pushed forward off its center-stand. Use micro-switches to protect removable panels and the lids of panniers etc. While at least one switch remains closed, the siren will sound.

Motorcycle Alarm Circuit Diagram

About tw1o minutes after the switches have been opened again, the alarm will reset. How long it takes to switch off depends on the characteristics of the actual components used. But, up to a point, you can adjust the time to suit your requirements by changing the value of C1.The schema board and switches must be protected from the elements. Dampness or condensation will cause malfunction.Without its terminal blocks, the board is small. Ideally, you should try to find a siren with enough spare space inside to accommodate it. Fit a 1-amp in-line fuse close to the power source.

This protects the wiring. Instead of using a key-switch you can use a hidden switch; or you could use the normally closed contacts of a small relay. Wire the relay coil so that it is energized while the ignition is on. Then every time you turn the ignition off, the alarm will set itself.When it`s not sounding, the schema uses virtually no current. This should make it useful in other circumstances. For example, powered by dry batteries and with the relay and siren voltages to suit, it could be fitted inside a computer or any thing else that`s in danger of being picked up and carried away. The low standby current and automatic reset means that for this sort of application an external on/off switch may not be necessary.

Sourced by : Streampowers